When run in UI and failing, the wrong count is displayed

The status message is also wrong in that it indicates that it completed without errors, even though there was an error at step 6.

On further investigation this is an odd case. It works correctly most of the time and only shows this brokeness if these steps happen:

1. /admin/config/development/batch_operations/operations/TestDo10ThingsWithError Run using the "Gracefully skip..." method. - it will show the correct message.
2. Run the same BatchOperation but this time as "fail on error..." - it will show the broken message indicating 4/10
3. subsequent runs show fine as long as it does not repeat 1 and 2

Released in 1.0.1-rc4 →